Replacement Cradle Mount 3M pad Only

In Stock & Ready to Ship!

Did you purchase a New Machine? Do you need to reattach your RideLite™?

Purchase this "New & Improved" super strong replacement 3M pad. This 3M pad is designed specifically for our Snowmobile/ATV application! The colder the temps drop the stronger the bond!

Please Note: This item does NOT come with the cradle mount assy. This order item is for a replacement 3M pad only!

Easy to Follow installation instructions are included!

Preview Instructions Below:

Tips on How to remove 3M mount & adhesive pad from machine:

The 3M pad adhesive pad is made to be removed by applying light heat with a heat gun or (hair) blow dryer.

1-Remove the light head from the cradle mount by loosening & removing the 2 steel lock nuts.

2-Apply light heat the rubber flexible base until the base is warm and the bond is loosened.

3-Start from one corner of the flexible base and peel up. Re-warm base during the process if needed.

4-Any 3M material that is remaining on the mating surface can rolled by hand into a ball then removed.

3M pad to Cradle Mount Install Instructions:

Disclaimer: Due to the many uncontrolled variances for a proper install, RideLite International LLC is Not responsible & will not warranty any bond failures under any circumstances.

1- Remove one side of the red or gray 3M cover tape

2- Place the 3M pad on a clean flat surface with the 3M tape (sticky side) facing up.

3- Firmly press all the mating surface areas of the cradle mount onto the exposed 3M pad.

Cradle Mount Install Instructions:

**Be sure the machine mounting surface is near room temp, dry & is free of dirt/wax. A surface temp that is to warm/hot will substantially weaken the bonding strength! Do Not use “Goo-Gone” to prep the mounting surface. It's petroleum base content will result in bond failure!

Disclaimer: Due to the many uncontrolled variances for a proper install, RideLite International LLC is not responsible & will not warranty any bond failures under any circumstances.

1- Without removing the red 3M adhesive cover tape hand position the mount onto the machine to determine exactly how it will be positioned. With the mount held in its determined position apply 2 small pieces of masking tape to mark out the mounting location. Apply the masking tape to the machine indexing or marking the front & side of the 3M mount base.

2- Remove the red 3M cover tape from the mount base & install the mount onto the machine within the masking tape guide lines.

3- Firmly press down on All the mating surface areas 3M pad to the machine.

Note: The cradle mount has an index hole in the center of the cradle bracket so the mount can also be attached to the machine with a fastener- if desired.

 *Remove Light Head from the cradle mount during summer storage

*Vermont purchases are subject to Vermont's state sales tax.

Replacement Cradle Mount 3M pad Only
  • Item #: Rep-3M
  * Marked fields are required.
Qty*
Price $8.99